DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Rear Camera / Data List.
(e) Read the Data List according to the display on the Techstream.
Chassis > Rear Camera > Data List| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Video Output Status | Output condition of video signal | OK or NG | OK: Output condition of video signal is normal NG: Output condition of video signal is abnormal | - |
| Destination Data Check | Verification of destination data | OK or NG | OK: Data verification normal NG: Data verification abnormal | - |
| RHD/LHD Signal Check | Verification of RHD/LHD signal | OK or NG | OK: Data verification normal NG: Data verification abnormal | - |
| Circumference Monitoring System Type Check | Verification of rear television camera assembly signal | OK or NG | OK: Rear television camera assembly normal NG: Rear television camera assembly abnormal | - |
| Display Drawing Function (Intuitive P/A Forward Detection) With or Without Comparing | Rear television camera assembly drawing function (intuitive P/A forward detection) with or without comparing | Match or Mismatch | OK: Rear television camera assembly normal Mismatch: Rear television camera assembly abnormal | - |
| EEPROM Status (Initial read) | Rear television camera assembly information | OK or NG | OK: Rear television camera assembly normal NG: Rear television camera assembly abnormal | - |
| CPU Communication Status | Rear television camera assembly information | OK or NG | OK: Rear television camera assembly normal NG: Rear television camera assembly abnormal | - |
| Number of DTC | Number of stored DTCs | min.: 0, max.: 255 | Number of DTCs will be displayed | - |
| Current Key Cycle | Cumulative number of times the engine switch was turned on (IG) | Min.: 0, Max.: 65535 time | Cumulative number of times the engine switch was turned on (IG) will be displayed | - |
| Current Key Cycle Elapsed Time | Time elapsed since the engine switch was turned on (IG) | Min.: 0, Max.: 1677721.5 s | Time elapsed since the engine switch was turned on (IG) will be displayed | - |
Terminals Of Ecu
Diagnosis SystemLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sliding Roof System: Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) Sliding roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs. CHECK DLC3 (a) Check the DLC3. Cli ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/o Automatic Headlight Beam Level Control System): LED Headlight LH (B2430,B2431)
DESCRIPTION These DTCs are stored when the low beam headlights do not illuminate, or a communication malfunction is detected between the headlight assembly and main body ECU (multiplex network body ECU). DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from B2430 ...