REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear television camera assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Rear television camera assembly |
| Parking assist monitor system | |
| Rear television camera view adjustment | Panoramic view monitor system | |
PROCEDURE
1. PRECAUTION
w/ Parking Assist Monitor System: Click here
w/ Panoramic View Monitor System: Click here
2. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here
3. REMOVE REAR TELEVISION CAMERA ASSEMBLY
| (a) Disconnect the connector. |
|
(b) Disengage the claw in the direction indicated by the arrow (1).
| Remove in this Direction (1) |
| Remove in this Direction (2) |
(c) Pull the rear television camera assembly in the direction indicated by the arrow (2) to disengage the guide and remove the rear television camera assembly.
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Fuel Rail / System Pressure - Too High (P008800)
DESCRIPTION Refer to DTC P008700. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P008800 Fuel Rail / System Pressure - Too High Although the ECM is requesting the fuel pump assembly (for high pressure side) to open the spill control va ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Windshield Deicer System: Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY *A w/o Seat Heater System *B w/ Seat Heater System (a) Disconnect the J43 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the valu ...