REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side television camera assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Side television camera view adjustment | Panoramic view monitor system | |
HINT:
PROCEDURE
1. REMOVE OUTER MIRROR
Click here
2. REMOVE NO. 1 OUTER MIRROR COVER
Click here
3. REMOVE NO. 2 OUTER MIRROR COVER
Click here
4. REMOVE OUTER MIRROR HOLE COVER
Click here
5. REMOVE SIDE TELEVISION CAMERA ASSEMBLY
| (a) Remove the 2 screws and side television camera assembly. |
|
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Wiper Rubber: Replacement
REPLACEMENT PROCEDURE 1. REMOVE REAR WIPER BLADE (w/o Rear No. 2 Seat) (a) Turn the engine switch on (IG). (b) Operate the rear wiper and when the rear wiper arm and blade assembly reach the point at which they reverse, turn the engine switch off. (c) Apply protective tape to the rear ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Propeller Shaft Assembly: Components
COMPONENTS ILLUSTRATION *A for Front Side *B for Rear Side *C for TMC Made *D for TMMC Made *E for Type A *F for Type B *1 FRONT CENTER FLOOR COVER *2 FRONT FLOOR COVER LH *3 NO. 2 ENGINE UNDER COVER *4 PROPELLER SHAFT GUARD *5 WIRING HARNESS C ...