Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Inspection

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Ultrasonic Sensor (for Front) / Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT CENTER ULTRASONIC SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

4 (BI) - 6 (EI)

Always

10 kΩ or higher

4 (BI) - 1 (BO)

Always

Below 1 Ω

5 (SI) - 2 (SO)

Always

Below 30 Ω

6 (EI) - 3 (EO)

Always

Below 1 Ω

If the result is not as specified, replace the front center ultrasonic sensor.

*a

Component without harness connected

(Front Center Ultrasonic Sensor)

2. INSPECT FRONT CORNER ULTRASONIC SENSOR

(a) for LH Side:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

4 (BI) - 6 (EI)

Always

10 kΩ or higher

4 (BI) - 1 (BO)

Always

Below 1 Ω

5 (SI) - 2 (SO)

Always

Below 30 Ω

6 (EI) - 3 (EO)

Always

Below 1 Ω

If the result is not as specified, replace the front corner ultrasonic sensor LH.

*a

Component without harness connected

(Front Corner Ultrasonic Sensor LH)

(b) for RH Side:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

4 (BI) - 6 (EI)

Always

10 kΩ or higher

4 (BI) - 1

Always

Below 1 Ω

5 (SI) - 2

Always

Below 30 Ω

6 (EI) - 3

Always

Below 1 Ω

If the result is not as specified, replace the front corner ultrasonic sensor RH.

*a

Component without harness connected

(Front Corner Ultrasonic Sensor RH)
    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ult ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL FRONT CORNER ULTRASONIC SENSOR RETAINER HINT: Perform this procedure only when replacement of the front corner ultrasonic sensor retainer is necessary. If a fron ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Pre-collision System Warning Buzzer: Inspection
    INSPECTION PROCEDURE 1. INSPECT SKID CONTROL BUZZER ASSEMBLY (a) Make sure that there is no looseness in the locking part and connecting part of the connector. (b) Disconnect the skid control buzzer assembly connector. (c) Check the connector and terminals for deformation and corrosio ...

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Brake Pedal: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal support assembly removal/installation are shown below. Necessary Procedure After Parts Removed ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2025 Copyright www.lexusrx.net
    0.0188