UTILITY
CANCEL COMMUNICATION FUNCTION PAUSING
HINT:
This function is used to cancel communication function pausing mode.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Utility / Cancel Communication Function Pausing.
Body Electrical > Telematics > Utility| Tester Display |
|---|
| Cancel Communication Function Pausing |
ALL READINESS
HINT:
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Clear the DTCs even if no DTCs are stored.
(e) Turn the engine switch off and wait for 2 minutes or more.
(f) Turn the engine switch on (IG).
(g) Perform the DTC judgment driving pattern to run the DTC judgment.
(h) Enter the following menus: Powertrain / Telematics / Utility / All Readiness.
Body Electrical > Telematics > Utility| Tester Display |
|---|
| All Readiness |
(i) Input the DTC to be confirmed.
(j) Check the DTC judgment result.
| Techstream Display | Description |
|---|---|
| If the judgment result shows Incomplete or N/A, perform the DTC confirmation driving pattern again. | |
| Normal |
|
| Abnormal |
|
| Incomplete |
|
| N/A |
|
(k) Turn the engine switch off.
Operation Check
Problem Symptoms TableLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Parking Assist Monitor System: Image from Camera for Parking Assist Monitor is Abnormal
DESCRIPTION The video signal from the rear television camera assembly is transmitted to the multi-display assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When "!" mark is displayed on the multi-display assembly after disconnecting the cable from the negative (-) battery terminal, correc ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Oil Pressure Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Disconnect the wire harness protector. *1 Wire Harness Protector (b) Disconnect the engine oil pressure switch assembly connector. (c) Start the engine. (d) Measure the resistance according to the v ...