PROBLEM SYMPTOMS TABLE
HINT:
Click here
Symptom | Suspected Area | Link |
---|---|---|
Vehicle status cannot be checked using the application. | Proceed to "Remote Service Malfunction" | |
Vehicle status alerts are not received by the application even if remote notification operation conditions are met. | Proceed to "Remote Service Malfunction" | |
Vehicle cannot be operated remotely using the application. | Perform remote door lock and unlock registration and check if the problem symptom recurs | |
Proceed to "Remote Service Malfunction" | |
Symptom | Suspected Area | Link |
---|---|---|
Engine does not start by remote engine start function. | Proceed to "Remote Engine Starter does not Operate" | |
Engine does not stop by remote engine stop function. | Proceed to "Remote Engine Starter does not Operate" | |
Symptom | Suspected Area | Link |
---|---|---|
The multi-display screen does not show a warning message even though a warning light turns on or the multi-information display indicates a warning. | Proceed to "Warning Notification Function Malfunction" | |
The multi-display screen shows a warning message even though no warning lights are on and the multi-information display does not indicate a warning. | Proceed to "Warning Notification Function Malfunction" | |
The multi-display screen shows a warning message different from the warning light or the multi-information display. | Proceed to "Warning Notification Function Malfunction" | |
Lexus RX (RX 350L, RX450h) 2016-2023 Repair Manual > Clearance Warning Buzzer (for Rear Side With Rear No. 2 Seat): Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 CLEARANCE WARNING BUZZER (a) Connect the connector. (b) Engage the clamp to install the No. 2 clearance warning buzzer. 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Click here 3. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY Click here 4. INSTALL ROPE HO ...
Lexus RX (RX 350L, RX450h) 2016-2023 Repair Manual > Front Camera System: Terminals Of Ecu
TERMINALS OF ECU CHECK FORWARD RECOGNITION CAMERA NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Do not apply excessive force to the forward recognition camera conn ...