INSPECTION
PROCEDURE
1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
(a) Connect 3 dry cell batteries (1.5 V) in series.
NOTICE:
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
| *a | Component without harness connected (Rear Height Control Sensor Sub-assembly RH) | *b | Low |
| *c | Standard Position | *d | High |
| *e | -45° | *f | 12° |
| *g | +45° | - | - |
(b) Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead to terminal 1 (SHG).
(c) Measure the voltage between terminals 1 (SHG) and 2 (SHRR) while slowly moving the link up and down.
Standard Voltage:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1(SHG) - 2(SHRR) | +45° (High) | 4.5 V |
| 1(SHG) - 2(SHRR) | 0° (Standard position) | 2.25 V |
| 1(SHG) - 2(SHRR) | -45° (Low) | 0.5 V |
If the result is not as specified, replace the rear height control sensor sub-assembly RH.
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Hood Lock Control Cable Assembly: Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY Click here 2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY Click here 3. REMOVE HOOD LOCK CONTROL CABLE COVER (a) Remove the screw. (b) Disengage the clamp and remove the hood lock control cable cover. 4. REMOVE HOOD LO ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Immobiliser System: Engine Immobiliser System Incorrect Assembly (B279C95)
DESCRIPTION If an ECM that is incompatible with the immobiliser system is installed, the ECM will store this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area Note B279C95 Engine Immobiliser System Incorrect Assembly An ECM that is incompatible with the immobiliser ...