INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
HINT:
PROCEDURE
1. INSTALL NO. 2 FLEXIBLE HOSE BRACKET
(a) Install the No. 2 flexible hose bracket to the rear upper control arm assembly with the bolt.
Torque:
18.8 N·m {192 kgf·cm, 14 ft·lbf}
2. INSTALL REAR FLEXIBLE HOSE
NOTICE:
When installing the rear flexible hose, minimize twisting of the hose.
| (a) Install a new clip to the rear flexible hose. NOTICE: Install the clip as far as it will go. |
|
(b) Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.
Torque:
Specified tightening torque :
15.2 N·m {155 kgf·cm, 11 ft·lbf}
NOTICE:
HINT:
Click here
13.38 N*m (136 kgf*cm, 10 ft.*lbf)
| (c) Install the rear flexible hose to the No. 2 flexible hose bracket with the 2 bolts. Torque: 18.8 N·m {192 kgf·cm, 14 ft·lbf} |
|
| (d) Install the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket. Torque: 30.4 N·m {310 kgf·cm, 22 ft·lbf} NOTICE: Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly. |
|
3. BLEED BRAKE LINE
Click here
4. INSTALL REAR WHEEL
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Curtain Shield Airbag Assembly (w/ Rear No. 2 Seat): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY NOTICE: When installing a curtain shield airbag assembly, have assistants hold it to prevent it from ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Brake Actuator: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CONNECT TECHSTREAM (a) Connect the Techstream to the DLC3 with the engine switch off. (b) Start the engine and run it at idle. (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Brake/EPB / Active Test. HINT: Refer to the Techstream operator's man ...