DESCRIPTION
Refer to DTC C05001F.
Click here
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C05003A | Left Front Wheel Speed Sensor Signal Has Too Many Pulses | When not in Dealer Mode (Signal Check) or Inspection Mode, the output of the speed sensor detected by the skid control ECU (brake actuator assembly) is too high for 5 second or more. | Skid control ECU (brake actuator assembly) |
| C05063A | Right Front Wheel Speed Sensor Signal Has Too Many Pulses | When not in Dealer Mode (Signal Check) or Inspection Mode, the output of the speed sensor detected by the skid control ECU (brake actuator assembly) is too high for 5 second or more. | Skid control ECU (brake actuator assembly) |
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Click here
PROCEDURE
| 1. | REPLACE BRAKE ACTUATOR ASSEMBLY |
(a) Replace the skid control ECU (brake actuator assembly).
Click here
| NEXT | | END |
Left Front Wheel Speed Sensor Signal Stuck Low (C050023)
Right Front Wheel Speed Sensor Circuit Short to Battery (C050612)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Dynamic Torque Control Awd System: AWD Control Switch Circuit
DESCRIPTION The 4WD ECU assembly changes the control mode in response to the "Lock Mode" signal from the AWD lock switch (combination switch assembly). WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When the 4WD ECU assembly is replaced with a known good one from another vehicle, it is necessary to ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Cylinder Block: Components
COMPONENTS ILLUSTRATION *A w/ Stud Bolt - - *1 CONNECTING ROD BEARING *2 CRANKSHAFT *3 CRANKSHAFT BEARING *4 CRANKSHAFT THRUST WASHER SET *5 CYLINDER BLOCK SUB-ASSEMBLY *6 NO. 1 OIL NOZZLE SUB-ASSEMBLY *7 PISTON *8 PISTON RING SET *9 STUD BOLT ...