DESCRIPTION
The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication.
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Click here
PROCEDURE
| 1. | INSPECT COMBINATION METER ASSEMBLY |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Enter the following menus: Body Electrical /Combination Meter / Active Test.
(d) Perform the Active Test of the combination meter assembly using the Techstream.
Body Electrical > Combination Meter > Active Test| Tester Display |
|---|
| Indicat. Lamp Slip |
(e) Check the combination meter assembly.
OK:
The slip indicator light turns on or off in accordance with the Techstream operation.
| OK | | REPLACE BRAKE ACTUATOR ASSEMBLY |
| NG | | INSPECT METER / GAUGE SYSTEM |
Slip Indicator Light Remains ON
Zero Point Calibration of Yaw Rate Sensor Undone (X204C)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Brake: Inspection
INSPECTION PROCEDURE 1. INSPECT PAD LINING THICKNESS (a) Using a ruler, measure the rear disc brake pad lining thickness. Standard Thickness: 9.5 mm (0.374 in.) Minimum Thickness: 1.0 mm (0.0394 in.) If a rear disc brake pad lining thickness is less than the minimum thickness, replace the rear ...
Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Before driving: Driving the vehicle
The following procedures should be observed to ensure safe driving:
Driving
1. With the brake pedal depressed, shift the shift lever to D.
2. Release the parking brake.
If the parking brake is in automatic mode, the parking brake is released
automatically
when shifting the shift lever to an ...