COMPONENTS
ILLUSTRATION
| *1 | COOL AIR INTAKE DUCT SEAL | - | - |
ILLUSTRATION
| *1 | AIR CLEANER CAP WITH AIR CLEANER HOSE | *2 | AIR CLEANER CASE SUB-ASSEMBLY |
| *3 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *4 | INLET AIR CLEANER ASSEMBLY |
| *5 | V-BANK COVER SUB-ASSEMBLY | *6 | NO. 1 FUEL VAPOR FEED HOSE |
| *7 | NO. 2 VENTILATION HOSE | - | - |
| N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | BRAKE MASTER CYLINDER O-RING | *2 | BRAKE MASTER CYLINDER SUB-ASSEMBLY WITH WAY |
| *3 | NO. 1 RESERVOIR HOSE | *4 | BRAKE LINE |
| *5 | BRAKE BOOSTER ASSEMBLY | - | - |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | * | For use with a union nut wrench |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *1 | BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY | *2 | BRAKE MASTER CYLINDER RING PIN |
| *3 | BRAKE MASTER CYLINDER SUB-ASSEMBLY | *4 | BRAKE MASTER CYLINDER TO WAY TUBE |
| *5 | MASTER CYLINDER RESERVOIR GROMMET | *6 | NO. 2 BRAKE TUBE WAY |
| *7 | BRAKE MASTER CYLINDER BODY | - | - |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | * | For use with a union nut wrench |
| ● | Non-reusable part | | Lithium soap base glycol grease |
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: GVIF Disconnected (from Extension Module to H/U) (B153A)
DESCRIPTION The radio receiver assembly and navigation ECU are connected via video signal (digital) lines. This DTC is stored when a video signal (digital) line is disconnected. DTC No. Detection Item DTC Detection Condition Trouble Area B153A GVIF Disconnected (from Extension Module ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lexus Enform System: DCM Data Signal Circuit between Navigation ECU and DCM
DESCRIPTION This circuit is used to send and receive signals between the DCM (Telematics Transceiver), radio receiver assembly and navigation ECU. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - DCM (TELEMATICS TRANSCEIVER)) (a) Disconnect the J157 DCM (T ...