REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
PROCEDURE
1. DRAIN BRAKE FLUID
NOTICE:
If brake fluid leaks onto any painted surface, immediately wash it off.
2. REMOVE COOL AIR INTAKE DUCT SEAL
Click here
3. REMOVE V-BANK COVER SUB-ASSEMBLY
Click here
4. REMOVE INLET AIR CLEANER ASSEMBLY
Click here
5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
Click here
6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Click here
7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Click here
8. DISCONNECT NO. 1 RESERVOIR HOSE
| (a) Slide the clip and disconnect the No. 1 reservoir hose from the brake master cylinder sub-assembly. |
|
9. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY WITH WAY
| (a) Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly with way. NOTICE:
|
|
| (b) Remove the 2 nuts and brake master cylinder sub-assembly with way from the brake booster assembly. NOTICE:
|
|
10. REMOVE BRAKE MASTER CYLINDER O-RING
(a) Remove the brake master cylinder O-ring from the brake master cylinder sub-assembly.
Components
DisassemblyLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Charging System: Charging Failure
PROCEDURE 1. CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION) (a) Start the engine and visually check that the generator rotor assembly (fan) in the generator assembly is operating. OK: The generator rotor assembly (fan) is operating. NG REPLACE GENERATOR PULLEY WITH CLUTC ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: AVC-LAN Circuit
DESCRIPTION Each unit of the navigation system connected to the AVC-LAN (communication bus) transmits switch signals via AVC-LAN communication. If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible. WIRING DI ...