DISASSEMBLY
PROCEDURE
1. REMOVE BRAKE MASTER CYLINDER TO WAY TUBE
(a) Secure the brake master cylinder sub-assembly with way in a vise.
NOTICE:
Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly and No. 2 brake tube way.
(b) Using a union nut wrench, remove the brake master cylinder to way tube. NOTICE:
|
|
(c) Remove the brake master cylinder sub-assembly and No. 2 brake tube way from the vise.
2. REMOVE NO. 2 BRAKE TUBE WAY
3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
4. REMOVE BRAKE MASTER CYLINDER RING PIN
(a) Secure the brake master cylinder sub-assembly in a vise.
NOTICE:
Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.
(b) Using a 5 mm pin punch and a hammer, tap out the brake master cylinder ring pin from the brake master cylinder sub-assembly. NOTICE: Do not drop the brake master cylinder reservoir assembly. |
|
5. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
(a) Remove the brake master cylinder reservoir sub-assembly from the brake master cylinder body.
6. REMOVE MASTER CYLINDER RESERVOIR GROMMET
(a) Remove the 2 master cylinder reservoir grommets from the brake master cylinder body. |
|
(b) Remove the brake master cylinder body from the vise.
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Television Camera (for Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side television camera assembly removal/installation are shown below. Necessary Procedure After Parts R ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Back Door: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL POWER BACK DOOR UNIT SET ASSEMBLY LH NOTICE: Do not apply any horizontal load to the power back door unit set assembly in order to prevent the piston rod from deforming. (a) Clean the bolt hole on the vehicle body. (b) Install the 2 bolts (A). NOTICE: Install the p ...