INSPECTION
PROCEDURE
1. INSPECT VACUUM PUMP VANE (for TMC Made)
| (a) Check that the vacuum pump vane or vacuum pump vane caps are not damaged or excessively worn out. HINT: If the vacuum pump vane or vacuum pump vane caps are damaged or excessively worn out, replace the damaged parts with new ones. |
|
| (b) Using a micrometer, measure length (A) of the vacuum pump vane with the vacuum pump vane caps removed. Minimum Length (A): 23.8 mm (0.937 in.) NOTICE: Measure the length 10 mm (0.394 in.) in from each end of the vacuum pump vane. HINT: If the length is not as specified, replace the vacuum pump vane and vacuum pump vane caps with new ones. |
|
| (c) Using a vernier caliper, measure length (B) of the vacuum pump vane with the vacuum pump vane caps installed. Minimum Length (B): 80.5 mm (3.17 in.) NOTICE: Measure the length 5 mm (0.197 in.) in from each end of the vacuum pump vane caps. HINT: If the length is not as specified, replace the vacuum pump vane and vacuum pump vane caps with new ones. |
|
2. INSPECT VACUUM PUMP HOUSING (for TMC Made)
| (a) Check that the areas shown in the illustration are not damaged or excessively worn out. HINT: If the areas shown in the illustration are damaged or excessively worn out, replace the vacuum pump assembly. |
|
Disassembly
ReassemblyLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Curtain Shield Airbag Assembly (w/ Rear No. 2 Seat): On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the curtain shield airbag assemblies. PROCEDURE 1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check. Clic ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Pad: Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment. PROCEDURE 1. PRECAUTION CAUTION:
...