ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
Click here
2. INSPECT BRAKE BOOSTER ASSEMBLY
Click here
3. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
Click here
4. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
Click here
5. INSPECT VACUUM WARNING SWITCH ASSEMBLY
(a) Start the engine and stop it after 1 or 2 minutes.
(b) Disconnect the connector from the vacuum warning switch assembly.
(c) Measure the resistance of the vacuum warning switch assembly.
Standard Resistance:
10 kΩ or higher
(d) With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.
Standard Resistance:
Below 1 Ω
(e) Connect the connector to the vacuum warning switch assembly.
6. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
Click here
7. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY
Click here
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Door Lock Control System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be dis ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear No. 1 Seat Assembly (for 60/40 Split Seat Type Lh Side): Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the seat frame may injure your hands. PROCEDURE 1. INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY LH (a) Temporarily install the rear seatback frame sub-assembly LH to the No. 1 seat cushion frame sub-assembly LH as shown i ...