INSTALLATION
PROCEDURE
1. INSTALL CHECK VALVE GROMMET
(a) Install a new check valve grommet to the brake booster assembly.
2. INSTALL VACUUM WARNING SWITCH ASSEMBLY (for TMC Made)
(a) Install the vacuum warning switch assembly to the brake booster assembly as shown in the illustration.
| *a | 30° +/- 20° |
| Up |
(b) Connect the connector to the vacuum warning switch assembly.
3. INSTALL VACUUM WARNING SWITCH ASSEMBLY (for TMMC Made)
(a) Install the vacuum warning switch assembly to the brake booster assembly as shown in the illustration.
| *a | 170° +/- 20° |
| Up |
(b) Connect the connector to the vacuum warning switch assembly.
4. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
Click here
5. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY
Click here
On-vehicle Inspection
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Knee Airbag Assembly: Installation
INSTALLATION PROCEDURE 1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (a) Check that the engine switch is off. (b) Check that the cable is disconnected from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery termi ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seat Inner Belt Assembly(for Rh Side): Inspection
INSPECTION PROCEDURE 1. INSPECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 Rear seat belt RH unfastened Below 1 Ω Rear seat belt RH ...