ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY
HINT:
Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Connect the Techstream to the DLC3 with the power switch off.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Active Test
(e) When the vehicle's tires are lifted off the ground and the Techstream is used to operate the electric parking brake, check the condition of the rear tires.
(f) According to the display on the tester, perform the Active Test.
Chassis > ABS/VSC/TRAC/EPB > Active Test| Tester Display |
|---|
| PKB Lock Control |
| Tester Display |
|---|
| PKB Release Control |
If the result is not as specified, inspect the electric parking brake actuator.
Click here
(g) Turn the power switch on (IG), push the electric parking brake switch to the lock side for 1 second and check that the parking brake indicator light (red) illuminates.
(h) Also, check that the brake warning light / yellow (minor malfunction) does not illuminate at this time.
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Charging System: Charging Failure
PROCEDURE 1. CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION) (a) Start the engine and visually check that the generator rotor assembly (fan) in the generator assembly is operating. OK: The generator rotor assembly (fan) is operating. NG REPLACE GENERATOR PULLEY WITH CLUTC ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Startability Malfunction (P160400)
DESCRIPTION This DTC is stored when the engine does not start even though the STA signal is input or when the engine takes a long time to start, and when the engine speed is low or the engine stalls just after the engine starts. Using the Techstream, the conditions present when the DTC was stored ca ...