DTC CHECK / CLEAR
CHECK DTC AND FREEZE FRAME DATA (USING TECHSTREAM)
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Brake/EPB / Trouble Codes.
Chassis > Brake/EPB > Trouble Codes(f) Check for DTCs.
Click here
NOTICE:
The electric parking brake system outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the electric parking brake system are output, refer to Diagnostic Trouble Code Chart for the relevant system.
| System | Proceed to |
|---|---|
| Vehicle Stability Control System | |
(g) Check the freeze frame data.
HINT:
for Freeze Frame Data: Click here
CLEAR DTC AND FREEZE FRAME DATA (USING TECHSTREAM)
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Brake/EPB / Trouble Codes.
(f) Clear the DTCs.
Chassis > Brake/EPB > Clear DTCsHINT:
When DTCs are cleared, the freeze frame data will also be cleared.
Terminals Of Ecu
Freeze Frame DataLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seat Assembly (for 60/40 Split Seat Type Lh Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Safety Connect System: Green Indicator Remains Off
DESCRIPTION After engine switch on (IG), the DCM (telematics transceiver) will enter into self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn off followed by the manual (SOS) switch green indicator illuminating and remaining on under normal operation. If nei ...