COMPONENTS
ILLUSTRATION
| *A | w/o AVS | *B | w/ AVS |
| *1 | FRONT AXLE ASSEMBLY | *2 | FRONT AXLE SHAFT NUT |
| *3 | FRONT DISC | *4 | FRONT DISC BRAKE CALIPER ASSEMBLY |
| *5 | FRONT DRIVE SHAFT ASSEMBLY | *6 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY |
| *7 | FRONT SPEED SENSOR | *8 | TIE ROD ASSEMBLY |
| *9 | FRONT SHOCK ABSORBER ASSEMBLY | *10 | COTTER PIN |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | | N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | | Toyota Body Grease W |
| Do not apply lubricants to the threaded parts | - | - |
ILLUSTRATION
| *1 | FRONT AXLE HUB SUB-ASSEMBLY | *2 | STEERING KNUCKLE |
| *3 | FRONT DISC BRAKE DUST COVER | - | - |
| N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
Front Axle Hub
On-vehicle InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: "No GPS signal" mark is displayed
CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System. Click here PROCEDURE 1. CHECK CABIN (a) Check the cabin for a ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Ecm: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ECM removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced ...