ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE FRONT WHEEL
Click here
2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
Click here
3. REMOVE FRONT DISC
Click here
4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
| (a) Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly. Maximum Looseness: 0.05 mm (0.00196 in.) NOTICE:
HINT: If the looseness exceeds the maximum, replace the front axle hub sub-assembly. |
|
5. INSPECT FRONT AXLE HUB RUNOUT
| (a) Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts. Maximum Runout: 0.05 mm (0.00196 in.) NOTICE:
HINT: If the runout exceeds the maximum, replace the front axle hub sub-assembly. |
|
6. INSTALL FRONT DISC
Click here
7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
Click here
8. INSTALL FRONT WHEEL
Click here
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Left Front Wheel Speed Sensor Signal Stuck Low (C050023)
DESCRIPTION Refer to DTC C05001F. Click here DTC No. Detection Item DTC Detection Condition Trouble Area C050023 Left Front Wheel Speed Sensor Signal Stuck Low Any of the following is detected:
When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Actuator Supply Voltage "A" Stuck On (P06579E)
MONITOR DESCRIPTION The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage is usually 0 V when the engine switch is turned off. If the output voltage is 7 V or higher when the engine switch is turned off, the ECM ...