Components
COMPONENTS
ILLUSTRATION
| *1 | TRANSFER EXTENSION HOUSING TYPE T OIL SEAL | - | - |
| ● | Non-reusable part | | MP grease |
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
Click here
2. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL
| (a) Using SST, remove the transfer extension housing type T oil seal from the transfer extension housing sub-assembly. SST: 09308-00010 NOTICE: Be careful not to damage the transfer extension housing type T oil seal contact surface or the inside surface of the transfer extension housing type T oil seal. |
|
3. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL
| (a) Using SST and a hammer, install a new transfer extension housing type T oil seal to the transfer extension housing sub-assembly until it reaches the position shown in the illustration. SST: 09325-20010 Standard Depth: 9.8 to 10.6 mm (0.386 to 0.417 in.) NOTICE:
|
|
(b) Apply a small amount of MP grease to the lip of the transfer extension housing type T oil seal.
4. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
Click here
Replacement
Transfer OilLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Seat Variable Cushion Switch: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat variable cushion switch removal/installation are shown below. Necessary Procedures After Parts Remo ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/ Automatic Headlight Beam Level Control System): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
Click here
If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-as ...