Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below when the transmission control shaft lever is moved to each position.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (RB) - 3 (PL)

4 (B) - 9 (L)

Shift lever in P

Below 1 Ω

Shift lever not in P

10 kΩ or higher

1 (RB) - 2 (RL)

Shift lever in R

Below 1 Ω

Shift lever not in R

10 kΩ or higher

1 (RB) - 8 (NL)

4 (B) - 9 (L)

Shift lever in N

Below 1 Ω

Shift lever not in N

10 kΩ or higher

1 (RB) - 7 (DL)

Shift lever in D, M, "+" or "-"

Below 1 Ω

Shift lever not in D, M, "+" or "-"

10 kΩ or higher

If the result is not as specified, replace the park/neutral position switch assembly.

*a

Component without harness connected

(Park/Neutral Position Switch Assembly)

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during park ...

    Adjustment
    ADJUSTMENT PROCEDURE 1. SECURE VEHICLE (a) Fully apply the parking brake and chock a wheel. CAUTION: Make sure to apply the parking brake and chock a wheel before performing this procedure. If th ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear No. 1 Seat Assembly (for Captain Seat Type): Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the seat frame may injure your hands. HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE SEAT ADJUSTER COVER CAP (a) Remove the 2 seat ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Camshaft Oil Control Valve (for Bank 1): On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY Click here 2. INSPECT CAMSHAFT TIMING GEAR BOLT (a) for intake side: (1) Check the stroke of the plunger in the center of the camshaft timing gear bolt. Standard Stroke: 4.5 mm (0.177 in.) or more HINT: W ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0088