INSTALLATION
PROCEDURE
1. INSTALL COOLING FAN MOTOR RH
(a) Cooling Fan Motor 100 W Type:
(1) Install the cooling fan motor RH with the 3 screws.
Torque:
2.6 N·m {27 kgf·cm, 23 in·lbf}
(2) Engage the 3 clamps.
(3) Connect the cooling fan motor RH connector.
(b) Cooling Fan Motor 200 W Type:
(1) Install the cooling fan motor RH with the 3 screws.
Torque:
3.9 N·m {40 kgf·cm, 35 in·lbf}
(2) Engage the 2 clamps.
(3) Connect the cooling fan motor RH connector.
2. INSTALL COOLING FAN MOTOR LH
(a) Install the cooling fan motor LH with the 3 screws.
Torque:
3.9 N·m {40 kgf·cm, 35 in·lbf}
(b) Engage the 3 clamps.
(c) Connect the cooling fan motor LH connector.
3. INSTALL FAN RH
NOTICE:
Do not reverse the position of the fan LH and fan RH when installing them. Doing so may damage the parts.
(a) Install the fan RH with the nut.
Torque:
6.3 N·m {64 kgf·cm, 56 in·lbf}
4. INSTALL FAN LH
NOTICE:
Do not reverse the position of the fan LH and fan RH when installing them. Doing so may damage the parts.
(a) Install the fan LH with the nut.
Torque:
6.3 N·m {64 kgf·cm, 56 in·lbf}
5. INSTALL RADIATOR ASSEMBLY
Click here
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Seat Heater System: Rear Right Seat Heat Sensor Circuit (B14C2)
DESCRIPTION Output to the rear seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change. DTC No. Detection Item DTC Detection Condition Trouble Area ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Lighting System: Engine Switch Illumination Circuit
DESCRIPTION The illuminated entry system controls the engine switch illumination. WIRING DIAGRAM PROCEDURE 1. PERFORM ACTIVE TEST USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Ele ...