COMPONENTS
ILLUSTRATION
| *1 | FRONT WHEEL OPENING EXTENSION PAD LH | *2 | FRONT WHEEL OPENING EXTENSION PAD RH |
| *3 | NO. 1 ENGINE UNDER COVER | *4 | NO. 3 ENGINE UNDER COVER |
ILLUSTRATION
| *A | for USA | - | - |
| *1 | BATTERY | *2 | INLET AIR CLEANER ASSEMBLY |
| *3 | BATTERY CLAMP SUB-ASSEMBLY | *4 | BATTERY TRAY |
| *5 | BATTERY CLAMP BOLT | *6 | BATTERY NEGATIVE TERMINAL |
| *7 | BATTERY POSITIVE TERMINAL | *8 | BATTERY INSULATOR |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | | N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *1 | HOOD LOCK ASSEMBLY | *2 | HOOD LOCK CONTROL CABLE COVER |
| *3 | HOOD LOCK RELEASE LEVER PROTECTOR | *4 | UPPER RADIATOR SUPPORT SUB-ASSEMBLY |
| N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with a union nut wrench |
| MP grease | - | - |
ILLUSTRATION
| *1 | LOWER RADIATOR SUPPORT | *2 | NO. 1 RADIATOR HOSE |
| *3 | NO. 2 RADIATOR HOSE | *4 | RADIATOR ASSEMBLY |
| *5 | RADIATOR SUPPORT CUSHION | *6 | FAN SHROUD ASSEMBLY |
| *7 | INLET NO. 1 OIL COOLER HOSE | *8 | OUTLET NO. 1 OIL COOLER HOSE |
Radiator
On-vehicle InspectionLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Drive Shaft Assembly: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR DRIVE SHAFT DUST COVER (a) Using SST, a steel plate and a press, install a new rear drive shaft dust cover. SST: 09527-21011 NOTICE:
The rear drive shaft dust cover should be completely installed.
Be careful not to damage the rear drive shaft dust cover ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Combination Meter: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during combination meter assembly removal/installation are shown below. Necessary Procedures After Parts Remove ...