ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FRONT ENGINE MOUNTING INSULATOR
(a) Disconnect the vacuum hose from the front engine mounting insulator assembly.
| (b) Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute. |
|
(c) Check that there is no change in the needle movement of the vacuum pump gauge.
OK:
Vacuum pressure holds.
(d) Check that there is no fluid leakage caused by a break in the diaphragm.
(e) Connect the vacuum hose to the front engine mounting insulator assembly.
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Fuel Lid Opener Motor Assembly: Components
COMPONENTS ILLUSTRATION *A w/o Rear No. 2 Seat *B for TMC Made *C for TMMC Made - - *1 DECK BOARD ASSEMBLY *2 DECK SIDE TRIM BOX RH *3 FRONT DECK FLOOR BOX *4 REAR DECK FLOOR BOX *5 REAR FLOOR FINISH PLATE *6 REAR NO. 3 FLOOR BOARD *7 REAR NO. ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Center Seat Outer Belt Assembly(w/ Rear No. 2 Seat): Installation
INSTALLATION PROCEDURE 1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY (a) Engage the 2 guides and temporarily install the rear center seat outer belt assembly with the 2 nuts. (b) Fully tighten the nut (A) and then the nut (B) to install rear center seat outer belt assembly. Torque: ...