Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FUEL PUMP

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Specified Condition

U - V

0.05 to 3.0 Ω

V - W

0.05 to 3.0 Ω

U - W

0.05 to 3.0 Ω

If the result is not as specified, replace the fuel pump.

*a

Component without harness connected

(Fuel Pump)

    Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembl ...

    Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL FUEL PUMP HINT: Perform "Inspection After Repair" after replacing the fuel pump. Click here (a) Apply a light coat of gasoline to a new O-ring. Then install the O ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System): Precaution
    PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System Pre-collision Sys ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Pre-collision System Warning Buzzer: Installation
    INSTALLATION PROCEDURE 1. INSTALL SKID CONTROL BUZZER ASSEMBLY (a) Connect the connector. HINT: Make sure to install the skid control buzzer assembly in the correct direction. (b) Engage the clamp to install the skid control buzzer assembly. NOTICE: If the skid control buzzer assembly ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0129