INSTALLATION
PROCEDURE
1. INSTALL OIL COOLER ASSEMBLY
(a) Install the No. 1 cylinder block insulator and 2 new O-rings.
(b) Install the oil cooler assembly with the 2 bolts and 2 nuts.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
(c) Connect the No. 4 water by-pass hose and No. 5 water by-pass hose to the oil cooler assembly, and slide the 2 clips to secure them.
(d) Install the hose clamp with the nut.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
2. INSTALL EXHAUST MANIFOLD ASSEMBLY LH
Click here
3. ADD ENGINE OIL
Click here
4. CHECK ENGINE OIL LEVEL
Click here
5. INSPECT FOR OIL LEAK
Click here
6. ADD ENGINE COOLANT
Click here
7. INSPECT FOR COOLANT LEAK
Click here
Removal
Lubrication SystemLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Camshaft Oil Control Solenoid (for Bank 2): Inspection
INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY HINT: Use the same procedure for the intake side and exhaust side. (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Conditio ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Immobiliser System: Engine Immobiliser System Incorrect Assembly (B279C95)
DESCRIPTION If an ECM that is incompatible with the immobiliser system is installed, the ECM will store this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area Note B279C95 Engine Immobiliser System Incorrect Assembly An ECM that is incompatible with the immobiliser ...