REMOVAL
PROCEDURE
1. REMOVE BACK WINDOW UPPER PANEL TRIM
Click here
2. REMOVE BACK DOOR TRIM COVER LH
Click here
3. REMOVE BACK DOOR TRIM COVER RH
HINT:
Use the same procedure as for the LH side.
4. REMOVE BACK DOOR LOCK COVER
Click here
5. REMOVE BACK DOOR TRIM BASE
Click here
6. REMOVE DOOR PULL HANDLE
Click here
7. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
8. REMOVE BACK DOOR TRIM PANEL ASSEMBLY
Click here
9. REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
| (a) Disconnect 2 connectors. |
|
(b) Remove the bolt.
(c) Disengage the 2 guides to remove the No. 1 amplifier antenna assembly.
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Ultrasonic Sensor (for Front): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Mirror Control System (w/o Memory): Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch
DESCRIPTION The multiplex network master switch assembly sends the mirror adjust switch signals to the main body ECU (multiplex network body ECU) via LIN communication. The main body ECU (multiplex network body ECU) then sends the received mirror adjust switch signals to the outer mirror control ECU ...