REMOVAL
PROCEDURE
1. REMOVE BACK WINDOW UPPER PANEL TRIM
Click here
2. REMOVE BACK DOOR TRIM COVER LH
Click here
3. REMOVE BACK DOOR TRIM COVER RH
HINT:
Use the same procedure as for the LH side.
4. REMOVE BACK DOOR LOCK COVER
Click here
5. REMOVE BACK DOOR TRIM BASE
Click here
6. REMOVE DOOR PULL HANDLE
Click here
7. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
8. REMOVE BACK DOOR TRIM PANEL ASSEMBLY
Click here
9. REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
(a) Disconnect each connector. |
|
(b) Remove the bolt.
(c) Disengage the guide to remove the No. 1 amplifier antenna assembly.
Lexus RX (RX 350L, RX450h) 2016-2022 Repair Manual > Sfi System: Brake Switch "B" Circuit Short to Battery (P070312)
DESCRIPTION The stop light switch assembly is part of a duplex system that transmits two signals: STP and ST1-. These two signals are used by the ECM to monitor whether or not the brake system is working properly. This DTC indicates that the stop light switch assembly is remaining on. When the stop ...
Lexus RX (RX 350L, RX450h) 2016-2022 Repair Manual > Rear Power Seat Control System(for Third Row): Position Sensor Circuit
DESCRIPTION When a fold seat control ECU receives signals from the fold seat switch assembly or No. 1 fold seat switch assembly, it operates the reclining motor and lifter motor of its corresponding rear No. 2 power seat. When the reclining motor or lifter motor is operating, the position sensor (Ha ...