CAUTION / NOTICE / HINT
HINT:
PROCEDURE
| 1. | VEHICLE BROUGHT TO WORKSHOP |
|
| 2. | CUSTOMER PROBLEM ANALYSIS |
| What | Vehicle model, system name |
| When | Date, time, occurrence frequency |
| Where | Road conditions |
| Under what conditions? | Driving conditions, weather conditions |
| How did it happen? | Problem symptoms |
|
| 3. | INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
HINT:
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
| 4. | CHECK CABIN |
(a) Check that condensation is not likely to occur in the cabin and that the temperature is not high or extremely low in the cabin.
OK:
Condensation is not likely being produced and the temperature is not high or extremely low.
HINT:
| NG | | SET CABIN TO APPROPRIATE TEMPERATURE |
|
| 5. | CHECK CAN COMMUNICATION SYSTEM* |
(a) Check if CAN communication system DTCs are output.
Click here
| Result | Proceed to |
|---|---|
| CAN DTCs are not output. | A |
| CAN DTCs are output. | B |
| B | | GO TO CAN COMMUNICATION SYSTEM* |
|
| 6. | CHECK FOR DTC* |
(a) Check for DTC.
Body Electrical > Navigation System > Trouble Codes| Result | Proceed to |
|---|---|
| DTCs are output. | A |
| DTCs are not output. | B |
| B | | GO TO STEP 10 |
|
| 7. | DTC CLEAR* |
(a) Refer to DTC Check / Clear.
Body Electrical > Navigation System > Clear DTCsHINT:
The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.
|
| 8. | RECHECK FOR DTC* |
(a) Refer to DTC Check / Clear.
Body Electrical > Navigation System > Trouble Codes| Result | Proceed to |
|---|---|
| DTCs are output. | A |
| DTCs are not output. | B |
HINT:
| B | | GO TO STEP 10 |
|
| 9. | DIAGNOSTIC TROUBLE CODE CHART |
(a) Find the output DTC in Diagnostic Trouble Code Chart.
Click here
| NEXT | | GO TO STEP 12 |
| 10. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table. | A |
| Fault is listed in Problem Symptoms Table. | B |
HINT:
If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms.
Click here
| B | | GO TO STEP 12 |
|
| 11. | PERFORM TROUBLESHOOTING BASED ON PROBLEM SYMPTOM |
(a) Refer to Terminals of ECU.
Click here
|
| 12. | CHECK CIRCUIT |
(a) Adjust, repair or replace as necessary.
|
| 13. | RECHECK FOR DTC |
(a) After clearing DTCs, recheck for DTCs.
Body Electrical > Navigation System > Clear DTCs Body Electrical > Navigation System > Trouble Codes
|
| 14. | PERFORM CONFIRMATION TEST |
| NEXT | | END |
System Diagram
System DescriptionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blower Motor Controller: Removal
REMOVAL PROCEDURE 1. REMOVE REAR NO. 2 SEAT ASSEMBLY Click here 2. REMOVE REAR FLOOR FINISH PLATE Click here 3. REMOVE REAR DOOR SCUFF PLATE RH HINT: Use the same procedure as for the LH side. Click here 4. REMOVE REAR DOOR INSIDE SCUFF PLATE RH HINT: Use the same procedure as for the LH sid ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Steering System: Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA NOTICE:
It is difficult to show the specified values (judgment values) clearly because freeze frame data values change significantly due to differences in measurement conditions, surroundings, or vehicle conditions. For this reason, there may be a problem even ...