Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

*: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

NEXT

3.

CHECK CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Click here

Result

Proceed to

CAN DTCs are not output.

A

CAN DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A

4.

CHECK FOR DTCs*

(a) Check for DTCs.

Click here

Body Electrical > Tilt&Telescopic > Trouble Codes

Result

Proceed to

DTCs are not output.

A

DTCs are output.

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A

5.

PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result

Proceed to

Problem symptom does not occur.

A

Problem symptom occurs.

B

B

GO TO STEP 7

A

6.

OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Terminals of ECU.

Click here

(b) Data List / Active Test.

Click here

NEXT

7.

REPAIR

NEXT

8.

CONFIRMATION TEST

NEXT

END

    Freeze Frame Data
    FREEZE FRAME DATA FREEZE FRAME DATA NOTICE: Freeze frame data values will vary depending on the measurement conditions, surroundings, or vehicle conditions. For this reason, there may be a problem ...

    IG Power Source Circuit
    DESCRIPTION When the engine switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU. The multiplex tilt and telescopic ECU also rec ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Vehicle Stability Control System: Brake System Control Module "A" System Voltage System Voltage Low (C137BA2)
    DESCRIPTION If a malfunction is detected in the power supply circuit, the skid control ECU (brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation. This DTC is stored when the +BS terminal voltage meets one of the DTC detection conditions due to a malfunction in ...

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Engine Unit: Installation
    INSTALLATION PROCEDURE 1. INSTALL STUD BOLT NOTICE: If a stud bolt is deformed or its threads are damaged, replace it. (a) Using an 8 mm socket wrench, install the stud bolt to the front No. 1 engine mounting bracket LH. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. INSTALL RADIATOR PI ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2025 Copyright www.lexusrx.net
    0.0097