INSPECTION
PROCEDURE
1. INSPECT STEERING HEATER SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)
| (a) Measure the voltage according to the value (s) in the table below. Standard Voltage:
HINT: As the circuit has a diode, perform the measurement in diode test mode, and do not mistake the polarity. |
|
(b) Measure the resistance according to the value (s) in the table below
Standard Resistance:
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 4 (IG1) - 16 (ECU) | Steering heater switch (Integration Control and Panel Assembly) is pushed | Below 1 Ω |
| Steering heater switch (Integration Control and Panel Assembly) is not pushed | 10 kΩ or higher |
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 12.3 Inch Display): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System. Click here HINT:
Use the table below to help determine the cau ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Thermostat: Installation
INSTALLATION PROCEDURE 1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY (a) Install a new gasket to the water inlet with thermostat sub-assembly. (b) Install the water inlet with thermostat sub-assembly with the 2 bolts and 2 nuts. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. CONNECT WATER BY-PAS ...