DESCRIPTION
This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.
HINT:
The certification ECU (smart key ECU assembly) controls the smart access system with push-button start (for Entry Function) related items that are customizable via the multi-display assembly screen.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
---|---|---|---|
B15F7 | Certification ECU Vehicle Information Reading/Writing Process Malfunction | Certification ECU (smart key ECU assembly) vehicle setting processing malfunction |
|
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
1. | CHECK CAN COMMUNICATION SYSTEM |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here
OK:
CAN DTCs are not output.
NG | GO TO CAN COMMUNICATION SYSTEM |
|
2. | CHECK SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Entry Function) |
(a) Check if the smart access system with push-button start (for Entry Function) is malfunctioning.
Click here
HINT:
Customization may not be possible depending on the malfunction in the smart access system with push-button start (for Entry Function).
OK:
No malfunctions are present in the smart access system with push-button start (for Entry Function).
NG | GO TO SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Entry Function) |
|
3. | CLEAR DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
|
4. | CHECK FOR DTC |
(a) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble Codes Result | Proceed to |
---|---|
DTCs are not output | A |
DTCs are output | B |
A | END |
B | REPLACE RADIO RECEIVER ASSEMBLY |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Air Fuel Ratio Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below. Necessary Procedures After Parts Removed/Ins ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Rear Drive Shaft Assembly: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR DRIVE SHAFT SNAP RING (a) Install a new rear drive shaft snap ring. NOTICE: Face the end gap of the rear drive shaft snap ring ...