DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Sending Malfunction (Navigation to APGS) | CAN bus connection error | CAN communication system |
| U0100 | Engine ECU Communication | CAN reception error | CAN communication system |
| U0129 | VSC(ECB)ECU Communication | CAN reception error | CAN communication system |
| U0140 | Lost Communication with Body Control Module | CAN reception error | CAN communication system |
| U0155 | Meter ECU Communication | CAN reception error | CAN communication system |
| U0164 | Air Conditioner ECU Communication | CAN reception error | CAN communication system |
| U023B | Lost Communication with Image Processing Module "B" | CAN reception error | CAN communication system |
| U0265 | Lost Communication with Image Processing Sensor A | CAN reception error | CAN communication system |
| U1110 | Clearance Sonar ECU Communication | CAN reception error | CAN communication system |
PROCEDURE
| 1. | CHECK DTC (CAN COMMUNICATION SYSTEM) |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Turn the engine switch off.
(c) Turn the engine switch on (IG) and wait for 30 seconds.
(d) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
| OK | | USE SIMULATION METHOD TO CHECK |
| NG | | GO TO CAN COMMUNICATION SYSTEM |
Certification ECU Vehicle Information Reading/Writing Process Malfunction (B15F7)
Noise OccursLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Window Regulator Motor (for Front Door): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. PRECAUTION NOTICE: After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) ba ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: Transmission Fluid Temperature Sensor "A" Circuit Short to Battery or Open (P071015)
DESCRIPTION The ATF temperature sensor converts the automatic transaxle fluid (ATF) temperature into a resistance value for use by the ECM. The ECM applies voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature r ...