CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
| 1. | CHECK IF A PROPER DISC IS INSERTED |
(a) Make sure that the disc is an audio disc or a disc with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
OK:
Normal disc.
HINT:
| NG | | CHANGE DISC |
|
| 2. | CHECK THAT DISC IS INSERTED PROPERLY |
(a) Check if the disc is inserted upside down.
OK:
Disc is properly inserted.
| NG | | INSERT DISC PROPERLY |
|
| 3. | CLEAN DISC AND RECHECK |
| (a) Clean the disc by wiping it clean with a soft cloth from the inside to the outside in a radial direction. OK: Malfunction disappears. NOTICE: Do not use a conventional record cleaner or anti-static preservative. |
|
| OK | | END (DISC WAS DIRTY) |
|
| 4. | REPLACE DISC AND RECHECK |
(a) Replace the disc with a new or known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
| OK | | END (DISC WAS FAULTY) |
| NG | | REPLACE RADIO RECEIVER ASSEMBLY |
Sound Quality is Bad Only when Disc is Played (Volume is Too Low)
Disc cannot be EjectedLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Outer Rear View Mirror: Inspection
INSPECTION PROCEDURE 1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH (a) Check the operation of the mirror surface. NOTICE: If the mirror surface is fully turned to the right, left, upward or downward position, the motor slips and produces a clicking noise. This is not a malfunction. (1) Disconnect ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Zero Point Calibration of Steering Angle Sensor Malfunction (X20D7)
DESCRIPTION Code Tester Display Measurement Item Trouble Area X20D7 Zero Point Calibration of Steering Angle Sensor Malfunction History of the steering angle sensor zero point calibration position differing from the stored value
Poor adjustment of the center position of the ste ...