CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
| 1. | CHECK MULTI-DISPLAY |
(a) Check if there is any foreign matter caught between the display and exterior frame of the multi-display.
OK:
No foreign matter is caught between the display and exterior frame of the multi-display.
HINT:
| NG | | REMOVE FOREIGN MATTER |
|
| 2. | CHECK TOUCH PANEL |
(a) Check for foreign matter on the display.
OK:
The display is clean.
| NG | | CLEAN DISPLAY AND RECHECK TOUCH PANEL |
|
| 3. | CHECK TOUCH SWITCH (OPERATION CHECK) |
| (a) Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check. Click here |
|
(b) Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
| OK | | REPLACE MULTI-DISPLAY ASSEMBLY |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Panel Switches do not Function
"No GPS signal" mark is displayedLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Panoramic View Monitor Switch: Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL GARNISH LH Click here 2. REMOVE FRONT DOOR SCUFF PLATE LH Click here 3. REMOVE COWL SIDE TRIM BOARD LH Click here 4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY C ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Short in Rear P/T Squib (LH) Circuit (B1925-B1928)
DESCRIPTION The rear pretensioner squib LH circuit consists of the airbag sensor assembly and rear No. 1 seat outer belt assembly LH. The airbag sensor assembly uses this circuit to deploy the pretensioner when deployment conditions are met. These DTCs are stored when a malfunction is detected in th ...