Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Voice is not Recognized

HINT:

• When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon.*1
• When the voice recognition prompt function is set to "On" and a voice command is recognized normally, the same voice command is repeated by the voice guidance function.*2
• If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
• The system cannot recognize voice commands when multiple people are speaking simultaneously.
• If the speaking speed is too fast or too slow, the recognition rate may decrease.
• The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
  • *1: w/ Voice Recognition Result Display Function
  • *2: w/o Voice Recognition Result Display Function

Voice Guidance does not Function

WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. ...

Cellular Phone Registration Failure

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precau ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Intelligent Clearance Sonar System: Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the intelligent clearance sonar system on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Trouble Codes. (f) Ch ...

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Canister: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during canister (charcoal canister assembly) removal/installation are shown below. Necessary Procedures After P ...