CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
HINT:
PROCEDURE
1. | CHECK USAGE CONDITION |
(a) Check that the vehicle and cellular phone meet the following conditions:
NOTICE:
If changing cellular phone settings, updating software, etc. is necessary, make sure to obtain the permission of the customer before performing it.
Click here
(b) Register the cellular phone again and check if it is registered correctly.
HINT:
If operation of the cellular phone or radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
Result | Proceed to |
---|---|
Cellular phone can be registered. | A |
Cellular phone cannot be registered. | B |
A | END |
|
2. | RESTART CELLULAR PHONE |
(a) Restart the cellular phone.
(b) Turn the engine switch off.
(c) Turn the engine switch on (ACC).
(d) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If operation of the cellular phone or radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
Result | Proceed to |
---|---|
Cellular phone can be registered. | A |
Cellular phone cannot be registered. | B |
A | END |
|
3. | BRING CELLULAR PHONE NEAR IN-VEHICLE DEVICE |
(a) Place the cellular phone close to the radio receiver assembly.
(b) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If operation of the cellular phone or radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
Result | Proceed to |
---|---|
Cellular phone can be registered. | A |
Cellular phone cannot be registered. | B |
A | END |
|
4. | CLEAR REGISTERED DEVICE INFORMATION |
(a) Clear all "Bluetooth" devices registered to the cellular phone and radio receiver assembly.
(b) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If operation of the cellular phone or radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
Result | Proceed to |
---|---|
Cellular phone can be registered. | A |
Cellular phone cannot be registered. | B |
A | END |
|
5. | RESTART CELLULAR PHONE |
(a) Restart the cellular phone.
(b) Turn the engine switch off.
(c) Turn the engine switch on (ACC).
(d) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If operation of the cellular phone or radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
Result | Proceed to |
---|---|
Cellular phone can be registered. | A |
Cellular phone cannot be registered. | B |
A | END |
|
6. | CHECK USING ANOTHER VEHICLE |
(a) Check if the cellular phone can be registered normally to another "Bluetooth" audio compatible vehicle of the same model.
HINT:
Result | Proceed to |
---|---|
Cellular phone can be registered. | A |
Cellular phone cannot be registered. | B |
A | REPLACE RADIO RECEIVER ASSEMBLY |
|
7. | CHECK USING ANOTHER CELLULAR PHONE |
(a) Using another "Bluetooth" compatible cellular phone, register the cellular phone and check that it is registered correctly.
HINT:
Result | Proceed to |
---|---|
Cellular phone can be registered. | A |
Cellular phone cannot be registered. | B |
A | END (ONLY A "Bluetooth" COMPATIBLE CELLULAR PHONE CAN BE USED) |
B | REPLACE RADIO RECEIVER ASSEMBLY |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Rear Differential Carrier Assembly: Reassembly
REASSEMBLY CAUTION / NOTICE / HINT NOTICE:
Before installation, thoroughly clean and dry each part and then apply Toyota Genuine Differential gear oil LT SAE 75W-85 GL-5 or equivalent to them.
Do not use alkaline cleaner for aluminum or rubber parts and rear differential case bolts.
Do not cl ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Rear Light Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY Click here 2. REMOVE REAR LIGHT ASSEMBLY (for Bulb Type Turn Signal Light) (a) Disconnect the ...