Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE

1. INSTALL FRONT BUMPER ASSEMBLY

(a) Move the front bumper assembly into position.

(b) Temporarily install the front bumper assembly with the 2 clips as shown in the illustration.

Install in this Direction

(c) Install the 4 bolts.

(d) w/ Headlight Cleaner System:

(1) Pull back the side of the front bumper assembly and connect the headlight cleaner hose.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.

(e) w/ Intuitive Parking Assist System or Fog Light:

(1) Pull back the side of the front bumper assembly, connect each connector.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.

HINT:

Use the same procedure for the RH side and LH side.

(f) Engage the 4 claws.

HINT:

Use the same procedure for the RH side and LH side.

(g) Install the 8 screws.

(h) Install the front bumper assembly with each clip.

(i) Connect each connector.

2. CONNECT FRONT FENDER MOULDING SUB-ASSEMBLY LH

(a) Engage the 5 claws and 2 clips.

(b) Connect the front fender moulding sub-assembly LH with the 4 clips.

3. CONNECT FRONT FENDER MOULDING SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

4. INSTALL COOL AIR INTAKE DUCT SEAL

(a) Install the cool air intake duct seal with the 9 clips.

5. ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)

Click here

6. ADD WASHER FLUID (w/ Headlight Cleaner System)

Click here

7. ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

Click here

8. PERFORM CALIBRATION (w/ Intelligent Clearance Sonar System)

Click here