REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fog light assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly | Front television camera view adjustment | Panoramic view monitor system | |
| Front bumper assembly (w/ Intelligent clearance sonar system) |
|
| |
HINT:
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here
2. REMOVE FRONT BUMPER ARM HOLE COVER LH (for LH Side)
for Type A:
Click here
for Type B:
Click here
3. REMOVE FOG LIGHT ASSEMBLY
(a) w/ Headlight Cleaner System:
| (1) Disengage the clamp. |
|
| (b) Disengage the clamp. |
|
| (c) Remove the clip. |
|
(d) Remove the 2 screws and fog light assembly.
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Brake: Components
COMPONENTS ILLUSTRATION *1 FRONT DISC BRAKE CYLINDER ASSEMBLY *2 FRONT FLEXIBLE HOSE *3 FRONT DISC BRAKE PAD *4 FRONT DISC BRAKE ANTI-SQUEAL SHIM *5 FRONT DISC BRAKE PAD WEAR INDICATOR PLATE *6 GASKET *7 ANTI-SQUEAL SPRING *8 FRONT DISC BRAKE ANTI-SQUEAL SHIM ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Roof Headlining (w/ Rear No. 2 Seat): Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 1 ROOF WIRE (a) When using a new roof headlining assembly: (1) Using a knife, cut the roof headlining assembly at the markings as shown in the illustration. *A for Standard Roof *B for Sliding Roof *a Marking *b Cut (b) Apply butyl tape as s ...