Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
Click here
2. REMOVE FRONT TURN SIGNAL LIGHT BULB
(a) for RH Side:
(1) Remove the bolt.
(2) Disengage the guide to disconnect the washer pipe.
| Remove in this Direction |
(b) Turn the headlight cord with the front turn signal light bulb as shown in the illustration to disconnect them as a unit.
| Disconnect in this Direction |
(c) Remove the front turn signal light bulb from the headlight cord.
3. INSTALL FRONT TURN SIGNAL LIGHT BULB
(a) Install the front turn signal light bulb to the headlight cord.
(b) Turn the headlight cord with the front turn signal light bulb as shown in the illustration to install them as a unit.
| Install in this Direction |
(c) for RH Side:
(1) Engage the guide to connect the washer pipe.
(2) Install the washer pipe with the bolt.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
4. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
Front Side Marker Light BulbLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Lost Communication with Cruise Control Module Missing Message (U010487)
DESCRIPTION The ECM communicates with each sensor and ECU via CAN communication. If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note U010487 ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Steering System: Assist Map Number Mismatch (C1582)
DESCRIPTION When an incorrect ECM, main body ECU (multiplex network body ECU) or skid control ECU (brake actuator assembly) is installed after the assist map has been written to the power steering ECU assembly, DTC C1582 is stored because the information stored in the power steering ECU assembly doe ...