COMPONENTS
ILLUSTRATION
| *A | for Driver Side | *B | for Front Passenger Side |
| *1 | COURTESY LIGHT ASSEMBLY | *2 | DOOR ARMREST COVER |
| *3 | FRONT DOOR INSIDE HANDLE BEZEL PLUG | *4 | FRONT DOOR NO. 1 STIFFENER CUSHION |
| *5 | FRONT DOOR TRIM BOARD SUB-ASSEMBLY | *6 | MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL |
| *7 | POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL | - | - |
ILLUSTRATION
| *1 | OUTER MIRROR INSTALL HOLE COVER | *2 | OUTER MIRROR PROTECTOR |
| *3 | OUTER REAR VIEW MIRROR ASSEMBLY | - | - |
| N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *A | for TMMC Made | - | - |
| *1 | NO. 1 OUTER MIRROR COVER | *2 | NO. 2 OUTER MIRROR COVER |
| *3 | OUTER MIRROR | *4 | OUTER MIRROR ACTUATOR ASSEMBLY |
| *5 | OUTER MIRROR HOLE COVER | *6 | SIDE TURN SIGNAL LIGHT ASSEMBLY |
ILLUSTRATION
| *A | w/ Power Retract Mirror | *B | w/o Panoramic View Monitor System |
| *C | w/ Panoramic View Monitor System | - | - |
| *1 | OUTER MIRROR RETRACTOR LH | *2 | ACTUATOR SUB-ASSEMBLY |
| *3 | HOUSING | *4 | SUPPORT |
| *5 | BASE SUB-ASSEMBLY | *6 | CLAMP |
| *7 | GASKET SUB-ASSEMBLY | *8 | FRAME SUB-ASSEMBLY |
| *9 | WIRE HARNESS SUB-ASSEMBLY | *10 | CONNECTOR HOUSING |
| *11 | ADAPTER | *12 | SPONGE TAPE |
| ● | Non-reusable part | - | - |
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 8 Inch Display): Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier
DESCRIPTION This circuit sends a signal to the stereo component amplifier assembly to mute noise. Due to this, the noise produced by changing the sound source ceases. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the c ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System): CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION If DTC U1000 is stored frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again even if the DTC is not output when rechecking for DTCs. DTC No. Detection Item DTC Detection Condition Trouble Area U1000 CAN Communication Failure ...