DESCRIPTION
This is the power source circuit to operate the radio receiver assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
| 1. | CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE) |
(a) Disconnect the J151 and J148 radio receiver assembly connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J148-1 (GND1) - Body ground | Always | Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J148-4 (+B1) - J148-1 (GND1) | Always | 11 to 14 V |
| J148-15 (ACC1) - J148-1 (GND1) | Engine switch on (ACC) | 11 to 14 V |
| J151-19 (IG) - J148-1 (GND1) | Engine switch on (IG) | 11 to 14 V |
| OK | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
Visual Mute Signal Circuit between Radio Receiver and Multi-displayLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Lock System: Terminals Of Ecu
TERMINALS OF ECU TERMINAL INSPECTION *a Component without harness connected (Steering Lock ECU (Steering Lock Actuator or Upper Bracket Assembly)) - - (a) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Input/Output Wiring Co ...
Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Intelligent Clearance Sonar
(ICS): Rear Cross Traffic Auto Brake function (if equipped)
If the Rear Cross Traffic Auto Brake function detects that a collision with
an
approaching vehicle is possible, the hybrid system output will be restricted to
restrain any increase in vehicle speed. (Hybrid system output restriction
control:
See A below.)
Additionally, if the accelerator ped ...