PROBLEM SYMPTOMS TABLE
NOTICE:
If the battery voltage is low, the mirror heater function may not operate. When "Operation of Electrical Items Restricted." is displayed on the multi-information display in the combination meter assembly, check the Data List item "Battery Control Count (Body ECU)".
Click here
HINT:
Symptom | Suspected Area | Link |
---|---|---|
Driver side power mirror cannot be adjusted with power mirror switch | Proceed to "Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch" |
|
Front passenger side power mirror cannot be adjusted with power mirror switch | Proceed to "Front Passenger Side Power Mirror cannot be Adjusted with Power Mirror Switch" |
|
Power mirror cannot be adjusted with power mirror switch | Proceed to "Power Mirror cannot be Adjusted with Power Mirror Switch" |
|
Mirror heater does not operate with rear defogger switch | Proceed to "Mirror Heater does not Operate with Rear Defogger Switch" |
|
Power retract mirrors do not operate with power retract mirror switch | Proceed to "Power Retract Mirrors do not Operate with Power Retract Mirror Switch" |
|
AUTO power retract mirrors do not operate | Proceed to "AUTO Power Retract Mirrors do not operate" |
|
Reverse shift-linked function of power mirrors does not operate | Proceed to "Reverse Shift-linked Function of Power Mirrors does not Operate" |
|
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Dynamic Radar Cruise Control System: Communication Error from VSC to ECM Invalid Serial Data Received (P163081)
DESCRIPTION The skid control ECU (brake actuator assembly) sends signals such as brake request signals to the ECM. If an abnormal signal is detected, the ECM stores DTC P163081. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output from P163081 Communication E ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Park / Neutral Position Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below when the transmission control shaft lever is moved to each position. Standard Resistance: Tester Connection Condition Specified Condition 1 (RB ...