DESCRIPTION
The main body ECU (multiplex network body ECU) receives remote control signals from the driver door key cylinder or electrical key transmitter sub-assembly. Then, the main body ECU (multiplex network body ECU) activates the power window motor and sends the remote control signals to the sliding roof ECU (sliding roof drive gear sub-assembly) via LIN communication. The sliding roof ECU (sliding roof drive gear sub-assembly) receives those signals and activates the sliding roof motor.
CAUTION / NOTICE / HINT
NOTICE:
Click here
*: w/o Canister Pump Module
Click here
Click here
Click here
Click here
PROCEDURE
| 1. | CHECK REMOTE CONTROL FUNCTION |
(a) Check the key-linked and wireless transmitter-linked functions.
Click here
| Result | Proceed to |
|---|---|
| Both the power windows and sliding roof operate by the key-linked and wireless transmitter-linked functions. | A |
| The sliding roof does not operate by the key-linked or wireless transmitter-linked function, but all of the power windows operate. | B |
| Both the power windows and sliding roof do not operate by the key-linked or wireless transmitter-linked function. | C |
| A | | USE SIMULATION METHOD TO CHECK |
| C | | GO TO POWER WINDOW CONTROL SYSTEM |
|
| 2. | CHECK SLIDING ROOF OPERATION |
(a) Check the sliding roof operation.
Click here
OK:
Sliding roof operates normally.
| NG | | GO TO OTHER PROBLEM (Sliding Roof does not Move by Operating Sliding Roof Control Switch) |
|
| 3. | REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
(a) Replace the sliding roof ECU (sliding roof drive gear sub-assembly).
Click here
|
| 4. | INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
(a) Initialize the sliding roof ECU (sliding roof drive gear sub-assembly).
Click here
|
| 5. | CHECK REMOTE CONTROL FUNCTION |
(a) Check the key-linked and wireless transmitter-linked functions.
Click here
OK:
The key-linked and wireless transmitter-linked functions operate normally.
| OK | | END (SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) WAS DEFECTIVE) |
| NG | | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
Key-off Operation Function Operates even if Operating Conditions are not Satisfied
Sliding Roof does not Move by Operating Sliding Roof Control SwitchLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Back Door System (w/ Outside Door Control Switch): Back Door Closer Operation Malfunction (B2250)
DESCRIPTION The multiplex network door ECU receives signals from the latch switch, position switch, pawl switch and back door courtesy switch, which are built into the back door lock assembly. Based on these signals, the latch position of the back door lock assembly is determined. DTC No. Detec ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Air Fuel Ratio Sensor: Inspection
INSPECTION PROCEDURE 1. INSPECT AIR FUEL RATIO SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 (HA1A) - 2 (+B) 1 (HA2A) - 2 (+B) 20°C (68°F) 1.6 to 3.2 Ω 1 (HA1A) - 4 (A1A ...