Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here

2. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.

(a) Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

3. INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

Click here

4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Click here

5. INSTALL REAR DOOR REAR GUIDE SEAL

Click here

6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Click here

7. INSTALL REAR DOOR GLASS RUN

Click here

8. CONNECT REAR DOOR WEATHERSTRIP

Click here

9. INSTALL REAR DOOR SERVICE HOLE COVER

Click here

10. INSTALL REAR DOOR NO. 2 TRIM BRACKET

Click here

11. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Click here

12. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Click here

13. INSTALL COURTESY LIGHT ASSEMBLY

Click here

14. INSTALL REAR DOOR ARMREST COVER

Click here

15. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Click here

16. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Click here

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

18. INITIALIZE POWER WINDOW CONTROL SYSTEM

Click here

19. INSPECT POWER WINDOW OPERATION

Click here