CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. | VEHICLE BROUGHT TO WORKSHOP |
|
2. | CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK |
|
3. | INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
4. | CHECK CAN COMMUNICATION SYSTEM* |
(a) Check if CAN communication DTCs are output.
Click here
Result | Proceed to |
---|---|
CAN communication DTCs are not output. | A |
CAN communication DTCs are output. | B |
B | ![]() | GO TO CAN COMMUNICATION SYSTEM |
|
5. | CHECK FOR DTC* |
(a) Check for DTCs.
Click here
Result | Proceed to |
---|---|
DTCs are not output. | A |
DTCs are output. | B |
B | ![]() | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
6. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
Result | Proceed to |
---|---|
Fault is not listed in Problem Symptoms Table. | A |
Fault is listed in Problem Symptoms Table. | B |
B | ![]() | GO TO PROBLEM SYMPTOMS TABLE |
|
7. | OVERALL ANALYSIS AND TROUBLESHOOTING |
(a) Data List / Active Test
Click here
(b) Terminals of ECU
Click here
(c) Inspection
(d) On-vehicle inspection
|
8. | ADJUST, REPAIR OR REPLACE |
|
9. | CONFIRMATION TEST |
NEXT | ![]() | END |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Airbag System: Curtain Shield Airbag Sensor Initialization Error (RH) (B1633)
DESCRIPTION The side collision sensor RH circuit (bus 1) consists of the airbag sensor assembly, door side airbag sensor RH and rear airbag sensor RH. The door side airbag sensor RH and rear airbag sensor RH detect impacts to the vehicle and send signals to the airbag sensor assembly to determine if ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Combination Light Assembly (w/ Rear No. 2 Seat): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR COMBINATION LIGHT ASSEMBLY Click here 2. INSTALL REAR LIGHT COVER (for Bulb Type Turn Signal Light) Click here 3. INSTALL R ...