DESCRIPTION
This DTC is stored when the front wiper motor and link assembly (wiper ECU) detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from |
|---|---|---|---|---|---|
| B1370 | ECU Malfunction | When the battery voltage is 9.5 V or more, a malfunction is detected for 10 seconds or more during the wiper ECU self-check. | Front wiper motor and link assembly | ○ | Front wiper motor and link assembly |
PROCEDURE
| 1. | CLEAR DTC |
(a) Clear the DTCs.
Click here
|
| 2. | CHECK FOR DTC |
(a) Turn the engine switch on (IG).
(b) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTC B1370 is not output. | A |
| DTC B1370 is output. | B |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE FRONT WIPER MOTOR AND LINK ASSEMBLY |
Lost Communication with Humidity/Rain Sensor LIN (B1279)
Wiper Switch Signal Mismatch between LIN and Line (B1372)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis. HINT:
If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor s ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Differential Carrier Oil Seal: Replacement
REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during diaphragm oil seal replacement are shown below. Necessary Procedures After Parts Removed/Installed/ ...