DESCRIPTION
Power source voltage is supplied to the air conditioning amplifier assembly when the engine switch is turned on (IG). This power is used for operating the air conditioning amplifier assembly, servo motors, etc.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
| 1. | CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - IG POWER SOURCE) |
(a) Disconnect the J43 air conditioning amplifier assembly connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J43-2 (IG+) - Body ground | Engine switch off | Below 1 V |
| J43-2 (IG+) - Body ground | Engine switch on (IG) | 11 to 14 V |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
| 2. | CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J43-4 (GND) - Body ground | Always | Below 1 Ω |
| OK | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
ECO Switch CircuitLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Ultrasonic Sensor (for Front): Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT CORNER ULTRASONIC SENSOR RETAINER HINT:
Perform this procedure only when replacement of the front corner ultrasonic sensor retainer is necessary.
If a front corner ultrasonic sensor retainer has been removed, replace it with a new one. Install the front c ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Stereo Component Amplifier: Installation
INSTALLATION PROCEDURE 1. INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY 2. INSTALL NO. 2 AMPLIFIER BRACKET (a) Install the No. 2 amplifier bracket with the 2 screws. 3. INSTALL NO. 1 AMPLIFIER BRACKET (a) Install the No. 1 amplifier bracket with the 2 screws. 4. INSTALL STEREO COMPONENT AMPLIFIER ASSE ...