COMPONENTS
ILLUSTRATION
*1 | HOOD LOCK ASSEMBLY | *2 | HOOD LOCK CONTROL CABLE COVER |
*3 | HOOD LOCK RELEASE LEVER PROTECTOR | *4 | INLET AIR CLEANER ASSEMBLY |
*5 | UPPER RADIATOR SUPPORT SUB-ASSEMBLY | - | - |
![]() | N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with a union nut wrench |
![]() | MP grease | - | - |
ILLUSTRATION
*1 | AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY | *2 | COOLER CONDENSER ASSEMBLY |
*3 | COOLER DRYER | *4 | DISCHARGE HOSE SUB-ASSEMBLY |
*5 | CAP | *6 | O-RING |
![]() | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
![]() | Compressor oil ND-OIL 12 or equivalent | - | - |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Engine Unit: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Rep ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rocker Panel Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY Click here 2. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY Click here 3. REMOVE NO. 6 ROCKER PANEL ...